How do I setup my D Link DNS 321?

How do I setup my D Link DNS 321?

To run the Easy Search Utility, insert the DNS-321 CD into your CD-ROM drive: Click Easy Search Utility. Highlight an available DNS-321 and click Configuration to access the web-based utility.

How do I access my Dlink network drive?

  1. Click Start > All Programs > Accessories > Run.
  2. Type \\ IP address of the router (default is 192.168.0.1)
  3. Example- \\192.168.0.1.
  4. Click OK.
  5. If you are prompted to enter a Username and Password, enter the credentials that you use to log in to the router’s web-based configuration utility.

How do I access USB storage from router on PC?

Follow the steps below to configure remote access settings.

  1. Log in to the web-based interface of the router.
  2. Go to Advanced > USB Settings > Sharing Access page.
  3. Tick the FTP(via Internet) checkbox, and then click Save.
  4. Refer to the following table to access your USB disk remotely.

How can I connect my external hard drive to my router without USB?

You can hook the usb drive up to a computer and share the drive over the network. If your router does not have the port then there is no way to add the port to the router. You will either need to hook it directly to a networked computer or buy a router with the usb plug.

How do I connect to DNS 320?

Select System Administrator and click the Login button (leave the password blank by default). Once you are logged in, click Management and then click Setup Wizard. Follow the on-screen instructions to configure your D-Link DNS-320L. Note: Please refer to the manual for more information.

Can I connect to router with USB?

Most modern routers have a USB port into which you can plug in a USB-compliant device to share with other devices on your network, like a printer or, in this case, an external hard drive. Once you’ve located the USB port on your router, go ahead and plug in your USB external hard drive.

How do I install a D-Link dns-323?

Insert a 3.5” SATA hard drive into each available drive bay. Make sure to align the drive connectors to the endpoints in the DNS-323. Gently push the drive in until it connects. 4. Attach the faceplate to the front of the device. D-Link DNS-3 User Manual10 Section – Installation 5. Connect an Ethernet cable into the available Ethernet port.

How do I access my dns-323 network Bay from Windows 10?

Here is how you gain back access to your D-Link DNS-323 network bay from Windows 10: Type “Turn windows features on or off” to your Windows 10 search box and open it. Scroll down till you find SMB 1.0/CIFS File Sharing Support. Click on the plus sign to expand it and mark only SMB 1.0/CIFS Client.

What is the dns-323?

The DNS-323 is designed for easy installation and allows remote access to important data via the LAN or WAN: Two Hard Drive Bays for 3.5” SATA Hard Drives of Any Capacity1

Does the D-Link DNS line of NAS devices support Windows 10?

The D-Link DNS line of NAS devices uses SMB v1.0 and does not support SMB 2.x. You must enable SMB 1.0 in Windows 10 to map a drive and view drive content. So no software update from D-Link, just reverting back to SMB1.