How do I reset my AP?

How do I reset my AP?

To reset a n Instant AP, perform the following steps:

1. Turn off the Instant AP.
2. Press and hold the reset knob using a small and narrow object such as a paperclip.
3. Turn on the Instant AP without releasing the reset knob. The power LED.
4. Release the reset knob. The Instant AP reboots with the factory default settings.

How do I reset my access point?

Unplug the access point’s power cable and wait for 30 seconds then plug it back in. Wait for the access point’s lights to appear solid. NOTE: Make sure to press and hold the Reset button properly. The lights on the access point should be blinking while you are holding the Reset button.

How do I factory reset my AP 515?

How to reset AP to factory settings?

Power up AP, hold mode button for 30 seconds, remove power and continue to hold mode button for 30 seconds, provide power again and continue to hold mode button for another 30 seconds. This didn’t work either. I have AP at my desk.

How to reset air-cap3702i-a-k9?

Factory Reset AIR-CAP3702I-A-K9 1 Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point. 2 Press and hold the MODE button while you reconnect power to the access point. 3 Hold the MODE button until the Status LED turns amber (approximately 10 to 12 seconds), and release the Button.

How do I Reset my Cisco wireless AP to default settings?

Reset Cisco Wireless AP to factory defaults Connect the console cable Unplug the power or network cable if connected to a POE switch Press and hold the Mode button Plug the power back into the AP Wait until the output on the console says button is pressed. Wait for button to be released… Once that

How do I Reset my access point to factory default settings?

Step 1: Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point. Step 2: Press and hold the MODE button while you reconnect power to the access point. Step 3: Hold the MODE button until the Status LED turns amber (approximately 10 to 12 seconds), and release the Button.