Who makes Gardner Bender?
Power Products, LLC
About Electrical Construction & Maintenance Division (ECM), Power Products, LLC: ECM, with its brands Gardner Bender, Sperry, and Calterm have been supplying electricians, do-it-yourselfers and maintenance technicians with a wide variety of innovative products for over 50 years.
What is the rim notch on a bender?
A. Rim notch/teardrop: Locates the center of a 3-point saddle bend. B. Arrow: Used to line up offset and outer marks for saddle bend.
What does a Gardner Bender do?
From large wire pulling equipment and hydraulic powered conduit benders to wire connectors, heat shrink, cable ties, hand tools, lighting and instruments, Gardner Bender provides complete solutions for any size electrical installation and maintenance project.
Where are Gardner Bender switches made?
5.0 out of 5 stars Finally a quality toggle switch. In the past, I have purchased those so-called heavy duty toggle switches (made in China), especially the orange ones.
How long is a 2 inch EMT 90?
EMT Large Radius 90° Elbows
| Trade Size | Metric Designator | Offset (B)* |
|---|---|---|
| 2 | 53 | 1530 |
| 2 1/2 | 63 | 879 |
| 2 1/2 | 63 | 1041 |
| 2 1/2 | 63 | 1187 |
What is 4 point saddle bend?
In its simplest form, a 4 point saddle is nothing more nor less than two offset bends a short distance apart. Normally used to cross larger obstructions than the 3 point saddle, they have a definite place on the job site. For saddles greater than about 3″, a 4 point saddle is probably the way to go.
What is a hoppy Bender?
The Hoppy Bender is hands down the most innovative and smartest bender on the market. We have revolutionized the way electricians bend pipe — it has never been easier or faster than it is now with the Hoppy Bender. Even the most complicated bends are made As Easy As 1,2,3.
How many degrees of bends can a bender do?
Even the most complicated bends are made As Easy As 1,2,3. Offsets, 3 & 4 point saddles, 90 degree bends always perfect and done in a fraction of the time! A “Stop” attached to the Bender head used to create exact and repeatable bends every time.
What is a stop on a Bender used for?
A “Stop” attached to the Bender head used to create exact and repeatable bends every time. Simplified “Multipliers” engraved into the bender for placing the “Stop” prior to making offsets and four-point saddles.
What are the “simplified “multipliers” engraved in the Bender?
Simplified “Multipliers” engraved into the bender for placing the “Stop” prior to making offsets and four-point saddles.