How do I connect my Brother DCP j315w to my laptop?

How do I connect my Brother DCP j315w to my laptop?

Turn your Brother machine on. Press Menu or Settings….2. Set up a Brother machine on a wireless network

1. Select Network. Press OK.
2. Select WLAN. Press OK. (This step might be skipped in some models.)
3. Select Setup Wizard. Press OK.

How do I connect my Brother DCP j315w to WIFI?

a On your machine, press Menu. Press a or b to choose Network and press OK. Press a or b to choose Setup Wizard and press OK. When Enable WLAN? is displayed, press OK to accept.

How do I fix init unable 48?

“Unable to Init. 48”

1. Confirm the error message appearing on the display.
2. Press Stop/Exit to temporarily clear the error message.
3. Unplug the machine from the power outlet.
4. Print a User Settings Report to test.
5. Your machine will require service.
6. Transferring stored faxes to another machine.

How do I connect my Brother MFC printer to Wi-Fi?

To set up your Brother machine on a wireless network:

1. Connect the power cord to your Brother machine and then connect it to an electrical socket.
2. Press Menu button on the machine’s control panel.
3. Press the Up or Down arrow key to select Network and press OK.
4. Press the Up or Down arrow key to select WLAN and press OK.

How do I install my Brother printer without the CD?

Turn on your computer if it isn’t already on. You should already have installed the printer drivers. Open the printer network driver and select the configure option, choosing the “Brother Peer-to-Peer Network.” Connect the USB cable to the printer and computer.

How do I install a new printer driver?

Download and install the driver from the printer manufacturer’s website

1. Select Start , then select Settings > Devices > Printers & scanners .
2. Under Printers & scanners, find the printer, select it, and then select Remove device.
3. After removing your printer, add it back by selecting Add a printer or scanner.

How do I reset the purge counter on my Brother MFC j220?

Purge Counter Reset Instructions

1. With the printer turned on and ready to print remove the power cable from the printer (or turn the printer off if you have a fixed power cable).
2. Hold down MENU/SET/START and re-insert the power cable/turn it back on.
3. Keep the button held down until the screen reads MAINTENANCE.

How do I fix Error 48 on Brother printer?

“Unable to Print 48”

1. Using both hands, use the finger holds on each side of the machine to life the scanner cover into the open position.
2. Carefully check the left (1) and right (2) hand corners and the center inside the machine and remove any paper scraps that may be jammed.